Liquid Silicone Rubbers - Medtech

Two-part, translucent silicone system designed for use with injection molding equipment
Rapid cure with no post-cure required
1:1 Mix Ratio (Part A: Part B)

Adhesives/Sealants - Medtech

Two-part, translucent, thixotropic, high tear strength silicone systems
MED1-4013 and MED3-4013 cure at room temperature and all three cure rapidly with the application of heat in an oven, or by a heat gun or lamp
Many bonding applications do not require the use of a silicone primer for suitable adhesion
Tin-free, does not require atmospheric moisture to cure
No curing byproducts such as acetic acid or methyl alcohol
Consistency allows products to be supplied in easy-to-use, airless side-by-side kits that eliminate mixing and deairing difficulties
MED1-4013 has a work time of ~15 minutes, MED2-4013 has a minimum work time of 15 hours, and MED3-4013 has a minimum work time of 60 minutes
MED1-4013 & MED3-4013 cure in less than 24 hours at room temperature

Low Viscosity Elastomers - Medtech

Flowable, two-part, clear, high durometer silicone
Cures with heat via addition-cure chemistry
1:1 Mix Ratio (Part A: Part B)

Primers - Medtech

Specially formulated primer
One-component primer supplied in VM&P Naphtha requires no mixing
Easy to use, air-drying, one-part primer designed for use with platinum-cured systems where conventional silicone primers are insufficient
Flash Point (TCC) of 17°C (63°F)
Convenient container sizes yield less waste

High Consistency Rubbers - Medtech

A two-part, high consistency elastomer designed for optimal performance in a wide range of applications
Produces a tough, durable, translucent elastomer when thermally cured
Has a non-tacky surface and no volatile byproducts or peroxide residues
Advantages include: lot-to-lot consistency and cost-effectiveness
1:1 Mix Ratio (Part A:B)